I’m Christopher Bahan, an A&P mechanic with Inspection Authorization and an ATP-rated former airline pilot. A twin Cessna has two engines, two props, a retractable gear system and, depending on the model, turbochargers and pressurization. That is a lot of airplane to buy, and a lot of places for an expensive problem to hide. Several of the problems below only showed up with the engines running.
What I check on a twin Cessna
The 300 and 400 series twins share a lot of design and many of the same trouble spots, so the inspection follows the same plan, adjusted for each model’s engines, gear and systems.
- Records: airframe, engine and propeller logbooks, AD compliance, Cessna Supplemental Inspection Document (SID) status, damage history and engine times.
- Engines: both Continentals, with compression, borescope of every cylinder, and a full engine run watching pressures and temperatures.
- Full-power fuel flow: checked on both engines on an evaluation flight. A Continental engine needs its full rated fuel flow at takeoff power, and the only way to verify it is at full power in flight.
- Turbochargers and exhaust: on turbocharged models, turbos, wastegates, exhaust stacks and slip joints, and signs of exhaust leaks.
- Exhaust AD inspection: on twin Cessnas covered by the turbocharged exhaust system airworthiness directive, the pre-buy includes every inspection item the AD details, not just a look at the stacks.
- Fuel system: engine-driven fuel pumps, fuel controls, lines and fittings, checked for leaks with the engines running.
- Landing gear: the gear system, actuators, linkages and a gear swing on jacks.
- Pressurization: on the 340, 414 and 421, door seals, controller and outflow valves, and how the cabin holds pressure.
- Airframe: wing spar areas, attach fittings and the belly for corrosion and cracks.
- Systems: props, deice, electrical, avionics and autopilot.
The evaluation flight is where the fuel flow check happens. It also shows what a ground inspection can’t, such as temperatures at full power and how the airplane and its avionics perform in the air.
Real finds on Cessna 421s
Fuel leaking from the fuel control
Found during the engine-running part of a pre-buy. Fuel near a hot engine is a fire risk, and a leak like this can be invisible with the engines shut down.
Failed fuel pump shaft seal
A different 421C, with a failed engine-driven fuel pump shaft seal. Fuel was pumping out of the seal cavity drain. With the engines off there may be little or nothing to see. A buyer should know about this cost before closing.
Main gear actuator bypassing
The left main gear hydraulic actuator was bypassing internally, with vibration in the gear system.
From a twin Cessna owner
★★★★★
“Had a small issue with my twin Cessna I needed a quick repair. Where other shops give the standard statement that it will be at least two weeks, Chris came within an hour and was able to get me all fixed up and airworthy again. Great job and will definitely use again.”
— Alex T., Google review
What does a twin Cessna pre-buy cost?
It depends on the scope you choose and the travel to reach the airplane. A twin takes more time than a single: two engines, two sets of records and more systems. Send me the listing and I’ll give you a firm quote for that airplane, with travel included, before you commit. See what goes into the cost.
Twin Cessna pre-buy FAQ
Can you inspect a twin Cessna outside Texas?
Yes. I travel to the aircraft anywhere in the U.S., so it doesn’t need to be flown anywhere before you own it.
Do you run the engines?
Yes. Two of the 421 finds on this page, the fuel control leak and the pump seal, only showed up with the engines running.
Can the inspection be turned into an annual?
When it’s practical, such as an airplane in the Houston area, a comprehensive pre-buy can be rolled into an annual if you buy, with credit for the inspection work already done. For an airplane across the country, the annual is usually done by a shop near the aircraft.
Buying a twin Cessna?
Send me the listing and I’ll do a free preliminary logbook and history review before you sign. See a sample inspection report or more real pre-buy findings.
Where I’ve inspected: hundreds of pre-buys in Houston and across Texas, plus inspections in Florida, Mississippi, Tennessee, Maryland, Arizona, California, Washington, Idaho and Canada.
